Axon Digidata 1322A Bedienungsanleitung PDF herunterladen (Seite 123)

122

If the file is just to be updated, save it by using the menu commands:

File -> Save

Updating the protocol file is very useful in resuming the experiment where you left off if a crash or power

outage has occurred (see Section 4.20).

4.15 Run the Experiment

4.15.1 Evoking Single Sweeps when Main Protocol is Not Running

Click on the ‘Single P0’, ‘(Single) P1’, ‘Single T0’ or ‘(Single) T1’ Run Buttons (see Fig. 3.1.5.1).

Alternatively, use the Run Menu to evoke the single sweeps when Main Protocol is not running (see Fig.

3.2.6)

Run -> Single P0 Sweep Stimulation F5

Run -> Single P1 Sweep Stimulation F6

Run -> Single T0 Sweep Stimulation Ctrl+F9

Run -> Single T1 Sweep Stimulation Ctrl+F10

Or finally, you can press the Run Function Keys to evoke the single sweeps when the Main Protocol is not

running.

Press To Run

F5 Single P0 Sweep Stimulation

F6 Single P1 Sweep Stimulation

Ctrl+F9 Single T0 Sweep Stimulation

Ctrl+F10 Single T1 Sweep Stimulation

Note that the ‘Repeat P0’, ‘(Repeat) P1’, ‘Repeat T0’ and ‘(Repeat) T1’ Run Buttons, Run Menu Item, and

Function Keys are disabled until the Main Protocol starts because they cannot run without the Main

Protocol running.

4.15.2 Running Continuous Acquisition when Main Protocol is Not Running

Click on the ‘Cont’ Run Button (see Fig. 3.1.5.1) to start Continuous Acquisition without the Main Protocol

running.

Alternatively, use the Run Menu to evoke the single sweeps when Main Protocol is not running (see Fig.

3.2.6)

Run -> Continuous Acquisition

There is no Run Function Key to press to start Continuous Acquisition when the Main Protocol is not

running.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 280 281

Keine Kommentare

Axon Digidata 1322A Bedienungsanleitung Seite 123